SymProjects Forum

General Category => General Discussions => Topic started by: r0gu3 on July 29, 2013, 02:51:17 pm

Title: (ProGauge) is it possible to poll for other data
Post by: r0gu3 on July 29, 2013, 02:51:17 pm

Hi Cristiano,
I was wandering when you update the firmware next or next software update. will there be additional daata in the drop down option box to choose from
ie
Water pressure ,
Voltage
Im missing these 2 and Im not sure if iracing or other sims would have these 2 data available so Progauge can also poll them.
thank you

Title: Re: (ProGauge) is it possible to poll for other data
Post by: r0gu3 on August 04, 2013, 07:32:51 pm

OK im going to change the question a little different, here.
Can anyone here tell me if I get a Proparts SPEK Volt gauge. since the progauge board do not have that option to get Voltage data from the sim, If I wire the gauge's input cable to 12 Volts DC output on the Progague board,will it read 12 volts on the gauge without damaging it please ?
Thank you in advance

Title: Re: (ProGauge) is it possible to poll for other data
Post by: mikeperry on August 05, 2013, 02:01:44 am

Quote from: r0gu3 on August 04, 2013, 07:32:51 pm

OK im going to change the question a little different, here.
Can anyone here tell me if I get a Proparts SPEK Volt gauge. since the progauge board do not have that option to get Voltage data from the sim, If I wire the gauge's input cable to 12 Volts DC output on the Progague board,will it read 12 volts on the gauge without damaging it please ?
Thank you in advance

That is how I have mine hooked up right now, just following the Spek directions.

Title: Re: (ProGauge) is it possible to poll for other data
Post by: Cristiano on August 05, 2013, 12:05:29 pm

Hi.
I can definitely add water pressure to the Pro-Gauge.
Voltage data is not supported at the moment because those gauges work in a different way.
you can connect the volt gauge signal wire to the 12V terminal on the Pro-Gauge and you will read a value around 12v.

Regards
Cristiano

Quote from: r0gu3 on August 04, 2013, 07:32:51 pm

OK im going to change the question a little different, here.
Can anyone here tell me if I get a Proparts SPEK Volt gauge. since the progauge board do not have that option to get Voltage data from the sim, If I wire the gauge's input cable to 12 Volts DC output on the Progague board,will it read 12 volts on the gauge without damaging it please ?
Thank you in advance

Title: Re: (ProGauge) is it possible to poll for other data
Post by: r0gu3 on August 07, 2013, 03:53:12 am

Ah Fantastic, thanks Mike, Thanks Cristiano, looks like im ordering a volt gauge

Almost done
http://wp.me/pLC9x-lX