SymProjects Forum

General Category => General Discussions => Topic started by: zhult on August 18, 2013, 06:17:24 am

Title: pro race question
Post by: zhult on August 18, 2013, 06:17:24 am

can i buttons on my wheel to change the displays? also where do i hook up for the buttons on the pro race

Title: Re: pro race question
Post by: Cristiano on August 20, 2013, 05:22:12 pm

Hello.
You can only use the bottons connected to the Pro-Race.

buttons connect like in this picture:
http://www.symprojects.com/wp-content/uploads/ProRace_94CC/nodiodes.jpg

from this page:

http://www.symprojects.com/shop/pro-race/

you should have received a ribbon cable with your display. use it co connect buttons to the orange connectors on the back of the display.

Regards
Cristiano

Quote from: zhult on August 18, 2013, 06:17:24 am

can i buttons on my wheel to change the displays? also where do i hook up for the buttons on the pro race

Title: Re: pro race question
Post by: zhult on August 21, 2013, 06:10:26 pm

yes i have ribbon cable. im just confused on where to hook to on the back of the pro race

Title: Re: pro race question
Post by: Cristiano on August 22, 2013, 10:46:48 pm

On the back of the display there is an orange connector, in the middle.

that is where the ribbon cable connects to.

Regards
Cristiano

Quote from: zhult on August 21, 2013, 06:10:26 pm

yes i have ribbon cable. im just confused on where to hook to on the back of the pro race