SymProjects Forum
General Category => General Discussions => Topic started by: mad-jo on September 05, 2013, 12:00:44 pm
-
hello,
can you help me to connect this switch http://www.conrad.de/ce/de/product/701424/Arcolectric-Kippschalter-Serie-3900-C3922BEAAA-1-x-EinAusEin-tastend0tastend-250-VAC-10-4-A-Schutzart-IP67/SHOP_AREA_17385?
to the pro-shift ?
wat to us it for next channel when i press to top and prev channel when i press down the switch..
thak you..
jo
-
I'm not sure what you mean by "next channel"/"previous channel", but I'll assume that's something inside a sim.
The hardware side of this should be simple enough. Connect the middle pin of the switch to one of the GND(negative) pins on the Pro Shift, as shown here:
(http://www.symprojects.com/shop/images/145/ProShift2.jpg)
It doesn't really matter which one as the board has a common GND, but for wire length I recommend using the GND pins in the "SWITCH" segment.
Now you can connect the remaining two pins on the switch to two of the positive pins in the "SWITCH" segment.
The pin number doesn't really matter, just keep in mind most switches have the bottom pin on when the switch is up, and the upper pin on when the switch is down.
-
thank you mortos... ill try it and report it ;)
greets jo
-
ugh now im confused :D
i wired the switch like you show me, but dont work..then i connect the middle pin to one positive and the 2 others to negative pins,,and its working..
but thx again..
-
Glad to hear you got it working, even though I managed to get the polarity the wrong way around :-X