SymProjects Forum

General Category => General Discussions => Topic started by: makuwaido on May 31, 2011, 07:49:12 pm

Title: Simscreen buttons connection
Post by: makuwaido on May 31, 2011, 07:49:12 pm

My Simscreen arrived today and now I'm ready to almost complete my dashboard. My question is regarding the buttons that are included and the cables supplied with it. How do I connect the cables to the buttons? The cable ends are the same used to connect LEDs (Pro shift, SPI-D).

Thanks.

Title: Re: Simscreen buttons connection
Post by: Cristiano on May 31, 2011, 08:36:05 pm

Hi.
Cut the connected at one side of the cable and strip off the plastic coating, exposing the copper wires.

then solder the wires on the buttons' connectors or, if you don't have a soldering iron, wrap the wires around the connectors.

Cheers
Cristiano