SymProjects Forum
General Category => General Discussions => Topic started by: paulieGTR on December 08, 2013, 06:50:35 pm
-
Hi there folks. :)
Anyone have a wiring diagram or know of a place where i can get one for a BMW clock cluster:
Specifically a... "BMW-E46-SMG-M3" and the year is "2001-2006".??
I'm just waiting on it being delivered next 48hrs(tue 10th 2013).
but, i will update this post with pics of the rear when it arrives.
I really appreciate your help guys.
tyvmia. :)
-
Unfortunately it is not possible to run this cluster (and most of the after 2000 years) with the Pro-Gauge or Rev Burner because it use the CAN BUS protocol.
I hope that Cristiano in the near future resolve this ;D
-
Unfortunately it is not possible to run this cluster (and most of the after 2000 years) with the Pro-Gauge or Rev Burner because it use the CAN BUS protocol.
I hope that Cristiano in the near future resolve this ;D
Thanx for the help Jadran.
It won't go to waste. :)
I'll canibilise it. ;)
-
It can be used :P but you need a e36 cluster to for do that. i read here in the forum a topic with some explanation of the transformation.
The topic: http://www.symprojects.com/forum/index.php?action=;topic=532.0 (http://www.symprojects.com/forum/index.php?action=;topic=532.0)
-
It can be used :P but you need a e36 cluster to for do that. i read here in the forum a topic with some explanation of the transformation.
The topic: http://www.symprojects.com/forum/index.php?action=;topic=532.0 (http://www.symprojects.com/forum/index.php?action=;topic=532.0)
Thankyou for the post H.G.
got an e36 on it's way. :)
-
But the wiring i don't know. If just need to open and make the wiring between the pin of the the needle panel of the e46 to the e36 or if need more stuff. Just ask to the user who create that topic