SymProjects Forum

General Category => General Discussions => Topic started by: stinky on July 29, 2011, 10:37:38 pm

Title: Computer Power Supply to power rev burner?
Post by: stinky on July 29, 2011, 10:37:38 pm

I have an old computer power supply in my racing rig to provide some lighting for some buttons in my button box.  Can I use the 12 volt (yellow wire) from the CPS to power the rev burner?

Title: Re: Computer Power Supply to power rev burner?
Post by: Cristiano on July 30, 2011, 04:19:25 pm

Hello.
Yes you can.
but because the output of the computer power supply is already regulated, you have to connect it to the rev burner following the schema in the picture at the end of this page:

http://www.symprojects.com/faq/power-supplies/

Regards
Cristiano