SymProjects Forum

General Category => General Discussions => Topic started by: blodo on August 06, 2018, 07:10:02 am

Title: JC-LED ... LED Voltage
Post by: blodo on August 06, 2018, 07:10:02 am

Hi

what volts do the LEDs need to have for the jc-led board?


thanks
Mitchell

Title: Re: JC-LED ... LED Voltage
Post by: Cristiano on August 06, 2018, 09:58:07 am

Hello.
LEDs don't require a specific voltage but a specific current, that with the JC-LED controller it is around 20mA. at full brightness.
This virtually works with all the leds.

Some bigger leds are built with smaller leds in series. this could not work, but we are talking about leds that are quite big, 20 or 30mm diamter.

if you have a link to a led that you are interested in, I can have a look.

Regards
Cristiano

Title: Re: JC-LED ... LED Voltage
Post by: blodo on August 06, 2018, 10:19:28 am

thanks Cristiano

here the link:

https://www.amazon.de/dp/B0788PTLX8/ref=cm_sw_r_cp_api_AfbABbDF99734

Mitchell

Title: Re: JC-LED ... LED Voltage
Post by: blodo on August 07, 2018, 04:48:32 pm

i ordered now on amazon and will it testet

Mitchell

Title: Re: JC-LED ... LED Voltage
Post by: blodo on August 11, 2018, 12:05:58 pm

ok, works fine

Mitchell