SymProjects Forum
General Category => General Discussions => Topic started by: Sokko on February 23, 2011, 12:03:01 pm
-
Hello,
I am very impressed with all products you made.
One thing is bothering me: cables.
If I order Rev-burner, SPI-D and Sim Screen is it possible to connect them in series with one USB cable? I would cut the cable and weld the wires directly to the boards.
With Eyefinity, G25, Leo's pedal adapter, mouse, keyb, headphones... last thing I need is 3 more USB cables.
-
Hello.
you can't connect usb devices in series, but you can install a small usb hub near your cockpit and have only one cable running to your computer.
Cheers
Cristiano
-
How much current is needed for these 3 devices.
As far as I am informed single USB port can provide 0.5Amps.
If I need more than that for all 3 than I have to find a hub with external power source and that would add one more cable on the cockpit.
So I would end up with 2 instead of 3 cables.
Just to clarify my worries. Currently, on my cockpit there are:
- 3 DVI cables for monitors (Eyefinity)
- 3 power cables for monitors
- USB cable for G25 + interconnection for shifter
- USB Leo Bodnar adapter for pedals
- power supply for G25
- USB for webcam
- USB for keyboard
- USB for mouse
- audio cable for headphones
Maybe I should get 7-ports, powerd USB hub and stick my keyb, mouse, camera and simprojects stuff in it. Now, that would be an improvement.
I hope that wont cause difficulties for your devices?
-
The Rev Burner + SPI-D + SiomScreen shoould stay below 500mA.
You can use the 7 ports hub, there is no problem with that.
Cheers
Cristiano
-
i bought a cheap 7 port powered usb hub to run all my gear and it works fine ;D