SymProjects Forum

General Category => General Discussions => Topic started by: elcastrol on November 08, 2011, 03:31:20 pm

Title: Shift Pro firmware update query
Post by: elcastrol on November 08, 2011, 03:31:20 pm

Hello! excuse my English, translator google

I want to upgrade the firmware of Pro Shift to use to swich to 4
For this I have to make a bridge between the 2 contacts "PROG"?

There are 2 firmware to download, a link does not work, but which one would have to use?

Very grateful!

Javier from Argentina

Title: Re: Shift Pro firmware update query
Post by: Cristiano on November 08, 2011, 03:58:06 pm

Hello.
Yes you have to link the two holes together and connect the usb cable.

At the moment the firmware that enables the 4 buttons is offline because it has been reported it is not very stable.

it wiil be available again, fixed, when the next version of SimDash will be available, at the end of November.

Thanks
Cristiano

Title: Re: Shift Pro firmware update query
Post by: elcastrol on November 08, 2011, 04:11:29 pm

Ok, if I understood well, I expect at the end of November?

Title: Re: Shift Pro firmware update query
Post by: Cristiano on November 09, 2011, 05:25:14 pm

Quote from: elcastrol on November 08, 2011, 04:11:29 pm

Ok, if I understood well, I expect at the end of November?

Yes, because the new firmware requires an update in SimDash, which should be available at the end of November.

So when next release is available, check the website because you will also find the firmware for the Pro Shift.

Thanks
Cristiano