SymProjects Forum

General Category => General Discussions => Topic started by: Mertons on December 05, 2011, 11:37:13 am

Title: Screws and nuts for the SPI-D & GI Pro
Post by: Mertons on December 05, 2011, 11:37:13 am
I assume that maybe this is one of the most stupid questions in the whole forum   :-[ , but the truth is I live in a small town and I can't find screws and nuts small enough for mounting my devices to the pot project I'm working on, so I will have to order them online, so I need to know the size of those pieces (if possible in mm, as here in Spain we don't work with inches) I guess thew are 2mm, but I prefer to get an "official" conformation. SO, can anybody tell me if 2mm screws and nuts are suitable for mounting the spi-d and GI pro?

Thanks in advance

P.D: I know i should buy a caliber tool, maybe someday...  ;)
Title: Re: Screws and nuts for the SPI-D & GI Pro
Post by: Cristiano on December 05, 2011, 02:29:23 pm
screws with 2mm diameter will definitely work. Probably 2,5mm is fine as well.

regards
Cristiano
Title: Re: Screws and nuts for the SPI-D & GI Pro
Post by: RD Hardware on December 06, 2011, 06:39:06 pm
M2.5 metric is the size you want ;)
Title: Re: Screws and nuts for the SPI-D & GI Pro
Post by: Mertons on December 15, 2011, 12:48:23 pm
Thanks 4 answers & sorry for delay, hard times at work   ::)

Regards
Title: Re: Screws and nuts for the SPI-D & GI Pro
Post by: torwith on March 02, 2014, 12:33:11 pm

I have a question about GI-Max. What is the distance (in mm Metric) from circuit bord to the outer limits on display?
(http://www.symprojects.com/shop/images/176)

Planning to build a dashboard ;-)
Title: Re: Screws and nuts for the SPI-D & GI Pro
Post by: Cristiano on March 02, 2014, 06:23:21 pm
the display is 8mm thick

Regards



Quote from: torwith on March 02, 2014, 12:33:11 pm

I have a question about GI-Max. What is the distance (in mm Metric) from circuit bord to the outer limits on display?
(http://www.symprojects.com/shop/images/176)

Planning to build a dashboard ;-)