SymProjects Forum

General Category => General Discussions => Topic started by: WhiteLightning on June 05, 2015, 03:00:26 am

Title: Actia Gauges With Progauge
Post by: WhiteLightning on June 05, 2015, 03:00:26 am

I was wondering if anyone knew if I can use an Actia Gauge cluster with the progauge. The only problem I see is that the Cluster uses a Master Gauge and all other gauges are slave gauges.

Title: Re: Actia Gauges With Progauge
Post by: bigmarky on June 05, 2015, 05:39:54 am

from the pics its fine
just need the pin diagram

find that first

Title: Re: Actia Gauges With Progauge
Post by: bigmarky on June 05, 2015, 05:42:39 am

wiring up true analog wire clusters is easy as it's just 3 wires

when you wire up a cluster, you need the service manual to see which pin outputs what

put 12v to ignition/battery terminals

and then just wire the grounds up

lastly the speedo/tacho - it'll work trust me

i've done 4 diff ones so far, zx6r/jaguar/tls1000/corvette

Title: Re: Actia Gauges With Progauge
Post by: WhiteLightning on June 06, 2015, 11:46:14 pm

http://www.centralstatesbus.com/2006_Blue_Bird_Manual/VisionServiceManual/13_Instrumentation.pdf

this is the cluster i want to use. with a diagram. I need to know how to do this.

Title: Re: Actia Gauges With Progauge
Post by: H.Guedes on June 09, 2015, 08:01:38 pm

You can´t use that. Simple problem... use canbus. For that you will need a canbus interface.

I bet nobody sold a canbus interface for that so, or you build one by yourself or choose another cluster.