SymProjects Forum
General Category => General Discussions => Topic started by: DonScott on August 20, 2015, 12:26:24 pm
-
Hey my fellow simracers !
Yesterday I cranked up the simulator and for some reason I got a "Drivers Not Installed" message. The Pro Gauge has worked flawlessly since I received it so of course I was a bit perplexed.
I tried a new USB cable, tried unplugging the board and a different USB port, still the same message. I tried uninstalling the software and re-installing, same message.
For troubleshooting purposes I replaced my new board with an older one I had purchased as a backup from another iRacer (for a future Indy sim build) and it worked fine. ???
The older board is a bit small than the new one and doesn't have all the jumper slots. They look quite different from each other but seem to work in a similar fashion.
I have sent Cristiano a message to the support email so I will await his advice, but I just thought I might see if anyone might be able to help me here.
Since I have a backup board and it seems to work fine, I'm in no rush. However I would like to see if I can get the new board I purchased back up and running.
Any advice would be helpful :)
Don
-
Got an email back already, AWESOME !!! Going to see if the advice in the email I got works, but I was happy to get such a fast and helpful response :)
-
same problem yesterday for me, killed my DLC-247 setup.... :(
Let me know if you have a solution ! :)