SymProjects Forum

General Category => General Discussions => Topic started by: marlboro1979 on October 14, 2015, 05:06:30 pm

Title: Firmware update issues
Post by: marlboro1979 on October 14, 2015, 05:06:30 pm

I have tried simdash and all was working ok, then it said new firmware was needed, updated and still it says it needs update, simdash v 6 and 7 tried with revburner v2 firmware.
Am at a loss as it now wont work at all, have tried the firmware updater with all firewalls and such off too. This is all on win10.

Title: Re: Firmware update issues
Post by: marlboro1979 on October 15, 2015, 01:46:02 pm

So the problem is sorted, kind of.

When i first start up simdash it says the firmware needs upgrading, if i then pull the usb out and put back in with simdash still running it comes up saying connected and all is good.
I have to do this every time i start simdash, but it works.

Title: Re: Firmware update issues
Post by: steve o on December 13, 2015, 08:31:13 pm

i cant seem to save any thing when setting up with the  dials in the correct way and have to reset the thing all the time >:(