SymProjects Forum

General Category => General Discussions => Topic started by: Denis Castilloux on February 28, 2016, 12:27:42 am

Title: Pro-Gauge / Pro Shift to a Mustang Dash 2004
Post by: Denis Castilloux on February 28, 2016, 12:27:42 am

Hi everyone! that as been a long time i did not post, glad to be back!

As my title says i need to connect a Mustang 2004 dash to my Pro-Gauge and a Pro shift for the light instrument, so anybody who can help my with this, it will be more than welcome.

Thanks
Denis

Title: Re: Pro-Gauge / Pro Shift to a Mustang Dash 2004
Post by: H.Guedes on May 13, 2016, 08:03:43 am

Quote from: Denis Castilloux on February 28, 2016, 12:27:42 am

Hi everyone! that as been a long time i did not post, glad to be back!

As my title says i need to connect a Mustang 2004 dash to my Pro-Gauge and a Pro shift for the light instrument, so anybody who can help my with this, it will be more than welcome.

Thanks
Denis

Hi. First do you have the pinout of dash? it helps a lot because if the dash use can-bus you can forget it. Far has i know, Pro-gauge don't support for now. The way you can run a dash with can bus system is using a arduino, can-bus shield and lots of practice writing code to put the thing working.