SymProjects Forum
General Category => General Discussions => Topic started by: rkipker on April 13, 2012, 08:11:00 pm
-
Hello and thanks for a great site and software. I just installed the Sim Race Hardware Dash Plate for then G25 (complete Assembly) and have the unit working fine with GSC. I am now trying to configure for S2U. Can anyone help me with this. I read there is nothing to do... but yet the shift lights do not work
The SimDash is recognizing the game running as the active simulator... but no lights, no nothing. Under View Data it does see gear, speed, rpm, but everything else is off.
Thanks and sorry I searched and read configure instructions on site.
SimDash Active Simulator says: "Need fo Speed Shift 2 is Running" but nothing responds
Thanks again
Randall
-
have you looked at whats supported in NFSS2? i ask as GSC has lots of data available, NFSS2 has little
http://www.symprojects.com/go/simdata
not all games are equal
-
Hello and thanks for a great site and software. I just installed the Sim Race Hardware Dash Plate for then G25 (complete Assembly) and have the unit working fine with GSC. I am now trying to configure for S2U. Can anyone help me with this. I read there is nothing to do... but yet the shift lights do not work
The SimDash is recognizing the game running as the active simulator... but no lights, no nothing. Under View Data it does see gear, speed, rpm, but everything else is off.
Thanks and sorry I searched and read configure instructions on site.
SimDash Active Simulator says: "Need fo Speed Shift 2 is Running" but nothing responds
Thanks again
Randall
Hi.
Gear position, speed and rpm is the only data available with the game.
shift lights need rpm value to work, so you should be able to configure them.
Regards
Cristiano