SymProjects Forum

General Category => General Discussions => Topic started by: Wombatman on July 06, 2012, 11:12:35 pm

Title: Spek pro and rev burner - how to wire?
Post by: Wombatman on July 06, 2012, 11:12:35 pm

So I just received my Ebay Spec Pro 5inch 11k tach and wanted to verify my pin connections to teh REV Burner

The spec tach as green/purple/black/red/white wires in the harness as shown. Now what goes to +/- S1 and S2   

It appears from the manual

Black ground
Green Tach Input
Red - Ignition Switch
White - Dash Lighting
Purple - Battery Power

Has anyone else got this combo and can confirm please?

Brad

Title: Re: Spek pro and rev burner - how to wire?
Post by: Wombatman on July 06, 2012, 11:41:02 pm

Here is what the manual that came with the tach shows

Title: Re: Spek pro and rev burner - how to wire?
Post by: Cristiano on July 07, 2012, 03:58:47 pm

Hello.

I don't have your rev counter but I can tell you how to connect it to the rev burner:

BLACK wire connect to the - terminal
GREEN wire connect to the S1 terminal
READ and WHITE wires connect to + terminal

I am not sure about the PURPLE one. I would say + terminal but I don't understant what it is for.