SymProjects Forum

General Category => General Discussions => Topic started by: oidipodas on September 23, 2012, 02:16:07 pm

Title: type r + revburner
Post by: oidipodas on September 23, 2012, 02:16:07 pm

hello
i have a type r rev counter and the revburner but i have problem calibrating,when i calibrate it in one test rpm setting such as 10% if i test another that i set before the rpm is not the same
 

Title: Re: type r + revburner
Post by: Mortos on September 23, 2012, 06:59:47 pm

If I understand correctly, you're calibrating to a single percentage and expect the tach to synchronise with your RevBurner.

Sadly, this isn't the way it works. You need to calibrate for each individual percentage so the needle corresponds to the chosen RPM setting.

Title: Re: type r + revburner
Post by: Cristiano on September 23, 2012, 09:06:55 pm

I think oidipodas means that if he calibrates the 10% point and then the 20% point, when he goes back to the 10% point it is not in the right position, but a little higher or a little lower.

this is caused by the poor quality of the rev counter

Title: Re: type r + revburner
Post by: oidipodas on September 24, 2012, 04:13:56 am

yes cristiano this is i mean, thanks for the info maybe i need to buy a better rev counter