SymProjects Forum

General Category => General Discussions => Topic started by: Enzo F. on February 01, 2013, 01:24:52 pm

Title: Use the Pro Shift's ground pins
Post by: Enzo F. on February 01, 2013, 01:24:52 pm

Hi,

is there a possibility to use the ground pins of the Pro Shift for my Leo Bodnar controller?
I have the problem that every 10 seconds all 4 buttons wired to the Bodnar controller's button pins and at the same time to the ground pins of the Pro Shift are "pushed" for a moment by themselves so that I can't use them ingame.

It would be very usefull as you need 4 extra ground pins to use all 12 buttons from the Bodnar controller (it only has 8 ground pins).

Title: Re: Use the Pro Shift's ground pins
Post by: Cristiano on February 01, 2013, 05:58:07 pm

I am not sure I understood everything, but I think the ground pins of the Pro Shift and the gound pins of the Sli-pro share the same ground, if they are both connected to the computer or the same usb hub.

But I  can't guarantee

Title: Re: Use the Pro Shift's ground pins
Post by: Enzo F. on February 14, 2013, 06:34:01 pm

Okay, I found out that it defenitely is a problem with the Bodnar joystick controller and not with the Pro Shift. But after all I think you can use the Pro Shift's ground pins for other joystick controllers. Don't know why the Bodnar controller has the "stuttering" I mentioned...