1
General Discussions / Re: Pro Shift Rev display
« on: September 27, 2012, 12:02:09 am »
I have a few saved already. When you have 1 saved the rest are not so long to figure out. It's not as bad as I thought. Love the product.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussions / Re: Pro Shift Rev display
« on: September 21, 2012, 11:00:56 pm »
Aww crap. At least now I know. Thanks for the quick reply
3
General Discussions / Pro Shift Rev display
« on: September 21, 2012, 12:31:24 am »
I have setup my Pro Shift to work well with the Corvette C6r in iRacing. I was wondering if there is a website to find exports or easier way to configure all the other cars. Or can I only do them 1 by 1?
4
General Discussions / Re: Pro Shift = Unknown Device
« on: September 08, 2012, 04:02:38 pm »
I will test it on a differant PC later on today to make sure it is not something on my end. If I get the same results then I will follow your instructions to arrange a replacement.
------------------------------------------------------------------------------------------------------------------------------------------------------------------
Tested on a differant Win7 x64 PC with the same results. GI Max worked with no problems but not the Pro Shift. Even bought a differant mini USB cable hoping it was only that.
The information you asked for is on it's way.
Thank you for your quick reponse.
------------------------------------------------------------------------------------------------------------------------------------------------------------------
Tested on a differant Win7 x64 PC with the same results. GI Max worked with no problems but not the Pro Shift. Even bought a differant mini USB cable hoping it was only that.
The information you asked for is on it's way.
Thank you for your quick reponse.
5
General Discussions / Re: Pro Shift = Unknown Device
« on: September 08, 2012, 02:46:16 am »
So far when I attempt to run the Bootloader it says, "Device not Detected. Verify device is in bootloader mode."
I am aware I must connect the Prog holes together with some "wire" then connect Pro Shift via USB and finally run the Bootloader.
Not knowing much about electronics I am using paper clips and safety pins as a connection. Should I be using a certain wire to ensure a proper connection?
I am aware I must connect the Prog holes together with some "wire" then connect Pro Shift via USB and finally run the Bootloader.
Not knowing much about electronics I am using paper clips and safety pins as a connection. Should I be using a certain wire to ensure a proper connection?
6
General Discussions / Pro Shift = Unknown Device
« on: September 07, 2012, 04:19:07 am »
In Win7x64 my GI-Max works fine in all USB ports. However the Pro Shift shows up as a Unknown Device. SimDash version 1.3.6 does not see it also. It is connected with the proper cable but I am wondering have I made a mistake and a DLC-247 is needed for the Pro Shift to work?
Pages: [1]
