Messages

1

General Discussions / Re: Rotary Encoders

« on: October 28, 2017, 06:18:09 pm »

Thank you for your answer!

I'll put those capacitors in and see if thats the problem.
Anyway I have this encoder: https://www.hestore.hu/prod_10028123.html#

2

General Discussions / Rotary Encoders

« on: October 24, 2017, 10:35:04 pm »

Hello, Ihave some problem with my encoders connected to the JC-LED.
When I rotate it, it gives 2 or 3 signals instead of one.
I think because simdash reads it too fast but I already set it to the max of 20 ms.
Is there any solution for this?

Thanks.

3

General Discussions / Re: Simscreen problem

« on: September 24, 2017, 02:12:50 pm »

Yes the contrast was the problem here thanks! 

4

General Discussions / Simscreen problem

« on: September 23, 2017, 12:07:40 am »

Hello

I have a problem with the simscreen. When I plug it in the screen is white not blue and because of this the info on the screen is hardly readable.
What did I do wrong?

Thanks

5

General Discussions / Re: Simdash buttons and leds

« on: July 30, 2017, 05:10:46 pm »

.

6

General Discussions / Re: Simdash buttons and leds

« on: July 17, 2017, 04:51:40 pm »

Thank you for you answer!

I am using the JC-LED.

7

General Discussions / Simdash buttons and leds

« on: July 15, 2017, 05:51:47 pm »

Hello,
I am new to this electronics building stuff so i'm sorry if my questions are stupid.
I got the buttons and the wires with the simdash but the buttons' pins are much wider than the ones on the wires, so how should i connect them?

My second question: I wonder if it is possible to assign two functions to one led? For example i want some of my rev lights to blink when i hit the pit limiter.

Thanks