Messages

1

General Discussions / Re: Commodore VY Cluster Wiring to RevBurner

« on: September 17, 2013, 12:36:15 pm »

Yeah RT1971 explained it to me, I was afraid of that. Should have done more research first... Guess I'll try putting it on Ebay and finding something else.. Thanks for the replies.

2

General Discussions / Commodore VY Cluster Wiring to RevBurner

« on: September 16, 2013, 11:05:03 am »

Hi guys,

Need some help! ... I'm trying to wire up the RevBurner to this Commodore VY instrument cluster... I checked out the thread below, someone has a VT Cluster working but unfortunately the pinout for my VY cluster is different, mine has 32 pins. I think I found the Posative (pin 1) & the ground (pin 17).. I can get the odometer to show up when I have the positive connected to positive Pin(1) & negative connected to Pin(17) what I think is the ground. I used the signal cable from the revburner to test the rest of the pins and I have found the following.

Pin (1) Posative
Pin (4) Dash lights
Pin ( Doors open
Pin (11) Right indicator
Pin (12) Beams
Pin (15) Left indicator
Pin (17) Gnd
Pin (20) Service Mode
Pin (31) Lock light

The connector has 1 to 32 pins.

But for some reason I cannot get the Tacho + Speedo to move, I know im missing something here... Does anyone have any suggestions they can offer or know what im doing wrong?

See photos.

http://s23.postimg.org/bjlt9mmkq/IMAG0417.jpg
http://s23.postimg.org/frl6w4de2/IMAG0418.jpg
http://s23.postimg.org/admeoknnu/IMAG0419.jpg
http://s23.postimg.org/3tjmi89my/IMAG0420.jpg


Thanks in advance.

(VT Cluster Thread)
http://www.symprojects.com/forum/index.php?topic=159.0