1
General Discussions / Re: DEPO Fuel Pressure Gauge Calibration Problem
« on: July 01, 2015, 08:12:00 pm »
I meant WA5267BLED btw, I have the 52mm gauge
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussions / DEPO Fuel Pressure Gauge Calibration Problem
« on: July 01, 2015, 08:06:51 pm »
I can't get my DEPO fuel pressure gauge (WA6067BLED) to zero properly with a 22uF50V cap and signal adapter installed as prescribed on the related symprojects page (http://www.symprojects.com/shop/depo-racing-60mm-fuel-pressure-gauge-wa6067bled/). 0% calibration on the configuration page is maxed out but the gauge only goes down to 5 PSI. Any ideas? The oil temp, oil pressure, and water temp gauges I've installed work great with Project Cars and GSC (oil & water temps only).
Also, I know that Project Cars (with 1.4 update applied) is supposed to support fuel pressure, but all of the cars I've driven so far (GT3 mostly) are stuck at 8 PSI, so which cars provide it? Thanks in advance for any assistance
Also, I know that Project Cars (with 1.4 update applied) is supposed to support fuel pressure, but all of the cars I've driven so far (GT3 mostly) are stuck at 8 PSI, so which cars provide it? Thanks in advance for any assistance
3
General Discussions / Re: Depo Gauges
« on: July 01, 2015, 07:59:59 pm »
Thanks for the feedback Loony!
4
General Discussions / Re: Depo Gauges
« on: May 02, 2015, 04:17:19 pm »22uf50v?
It seems i need 2 of them
1 for water and 1 for oil
Did the 22uF50V capacitor and signal adapter setup work ok with your Depo gauges?
Pages: [1]
