1
General Discussions / Re: Pro Shift
« on: June 13, 2011, 03:52:37 pm »
Does the Pro Shift also work with SMD leds? Or will it only work with 5 and 3 millimeter leds?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussions / Re: CAN-bus communication
« on: June 13, 2011, 03:39:02 pm »
Ambitieus project 
.
But I think the few hours of coding you what to put in it wont be enough.
Problems I think you will run in to:
- You don't know the exact message the car gives to the gauges cluster. Porsche will never release these messages/code. These are not standaard messages, only the protocol is standaard.
- You don't know how many times the message is send, 1 time or 10000 times per millisecond???
- The cluster will probably have some security protection on it. The chip in the carkey needs to match the security protection in the cluster, otherwise nothing works.
There are ways to get a hold on the first two problems, but there costly, not 100% and you need the car.
http://www.peak-system.com/Home.59.0.html?&L=1
http://katho.caneye.be/pagina.aspx?id=1
.But I think the few hours of coding you what to put in it wont be enough.
Problems I think you will run in to:
- You don't know the exact message the car gives to the gauges cluster. Porsche will never release these messages/code. These are not standaard messages, only the protocol is standaard.
- You don't know how many times the message is send, 1 time or 10000 times per millisecond???
- The cluster will probably have some security protection on it. The chip in the carkey needs to match the security protection in the cluster, otherwise nothing works.
There are ways to get a hold on the first two problems, but there costly, not 100% and you need the car.
http://www.peak-system.com/Home.59.0.html?&L=1
http://katho.caneye.be/pagina.aspx?id=1
Pages: [1]
