1
General Discussions / Re: Commodore VY Cluster Wiring to RevBurner
« on: September 17, 2013, 08:59:47 am »
I have sent you a PM, doesn't look promising as they get most of there info by serial link.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussions / Re: Aussie Commodore VT dash
« on: May 25, 2011, 03:43:43 pm »
Probably something I was doing wrong, if I didn't unplug the power from the board before disconnecting and reconnecting USB it would not get recognized. Only seemed to happen after flashing to Speedo .hex file.
Anyway heres the pinouts for the VT dash.
If you can't get hold of the genuine plug these plugs http://www.symprojects.com/shop/20-pin-dual-female-splittable-jumper-wire-300mm/ that Symprojects sell fit perfectly, I just used ones from a gutted 386.
Anyway heres the pinouts for the VT dash.
If you can't get hold of the genuine plug these plugs http://www.symprojects.com/shop/20-pin-dual-female-splittable-jumper-wire-300mm/ that Symprojects sell fit perfectly, I just used ones from a gutted 386.
3
General Discussions / Aussie Commodore VT dash
« on: May 25, 2011, 06:30:20 am »
First of all love the new forum and I would like to apologize to Cristiano for not replying to your last email many many months ago. (life got in the way big time)
Just like to let any Aussies on here that I have a VT Commodore Dash working, both Speedo and Tach, only 1 at a time as I need another RevBurner.
I have pinouts available if anyone interested and also .xml settings to save you some work.
To get the Speedo working I had to move the 5v-12v jumper to 12 volts for it to work, kept getting critical error in Simdash software when trying to calibrate.
Heres a quick vid of speedo working and you will also notice the overspeed alert also works which I will adjust as pit speed warning.
http://youtu.be/UoL674aNZrM
Just like to let any Aussies on here that I have a VT Commodore Dash working, both Speedo and Tach, only 1 at a time as I need another RevBurner.
I have pinouts available if anyone interested and also .xml settings to save you some work.
To get the Speedo working I had to move the 5v-12v jumper to 12 volts for it to work, kept getting critical error in Simdash software when trying to calibrate.
Heres a quick vid of speedo working and you will also notice the overspeed alert also works which I will adjust as pit speed warning.
http://youtu.be/UoL674aNZrM
Pages: [1]
