Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - RAVEN

Pages: [1]
1
Show off your build / Re: My WIP dashboard / cockpit
« on: January 15, 2014, 09:59:37 pm »
Unfortunally I don't have pro-gauge system, so for a while this is my actual solution.
My intention was to be helpful for those member who already buy 2 Rev burner and would like to see something else move.

2
Show off your build / Re: My WIP dashboard / cockpit
« on: January 15, 2014, 01:06:30 am »
Hi, to everyone!!

About the fuel level gauge, I used a resistor between the pin 1 - 3 of black connector;
470 ohm = 100%,
235 ohm (470 x 2 parallel) = 50%,
156 ohm (400 x 3 parallel) = 25%,
or you can easily use a 1Kohm linear potentiometer.

To set the temp level gauge around 50%, you can connect between the pin 17 - 18 of blu connector, a 750 ohm (1.5kohm x 2 parallel) or a 10Khm linea potentiomenter.




Pages: [1]
hit counter