9
« on: May 23, 2011, 11:26:30 am »
Hi guys, I'm new to this so hoping you can help.
I have just setup GI-Max, SPID, Pro Shift and Rev Burner (within the last hour) and all is good except I can't get my Rev Burner to read right.
I have a Tacho that has a max RPM of 11000 but I can't get it to go that high.
I have selected 4 Cylinder on the Tach and Sim dash but if I go higher then approx 31200 PPM the needle stops climbing and starts dropping. The highest I can get is about 9200RPM.
I have played around and tried 6 and 8 cylinder settings just for the sake of it but same problem.
Can anyone help?
Also I tried to do a firmware upgrade on the Rev Burner but there is no jumber on the board to change to get into the right mode. Is this a different version apart from V1 and V2 listed on the site?
Thanks