Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mikeperry

Pages: [1]
1
General Discussions / DLC 24/7 output data request.
« on: July 23, 2014, 11:04:02 pm »
I was wondering if it was all possible if you could output the data in iRacing of the following for 7 segment LEDs,

Front ARB
Rear ARB
Weight Jacker
Fuel map
Brake Bias

I'm currently working on a Indy Car Display and it would make my life so much easier if the data I listed above be added to the already great data output the DLC 24/7 has.

Thanks.

Mike

2
General Discussions / Need some DLC247 help
« on: June 17, 2014, 11:43:02 pm »
I have a DLC247 and 50 5050 SMD RGB LED (http://www.superbrightleds.com/moreinfo/component-leds/rgb-5050-smd-led-120-degree-viewing-angle/322/)

I want to use them for a Caution/Green/Blue flag light system for iRacing.

So I was wondering if it would work like this

16  LED's set to green Channel for Green Flags
16  LED's set to the blue channel for blue flags
16  LED's set yo to the red and green channels for yellow flags

Is this possible with the DLC247, if so how would I wire this up to work?

If someone would be nice to help it would be great!

Thanks

3
I hope this can happen, I have invested in an entire dash for the NASCAR Sprint Cup.

I currently have a revburner board running the 5" Proparts Spek Tach, but would love to get the other 6 Spek 2 1/16" Gauges going with iRacing.

Here is  a video of them all running in demo mode powered by a single revburner board.

http://www.youtube.com/watch?v=OiV-0f0bfJ4

4
General Discussions / Have not recieved my order I placed on Sept 3, 2011
« on: September 23, 2011, 08:37:46 pm »
I was wondering if my order has been shipped, and when it was shipped.

Thanks

5
General Discussions / I have a product question.
« on: September 09, 2011, 11:42:03 am »
I was wondering is Symprojects going to make a product so I can run a complete set of gauges. I purchased the revburner for my 5" Proparts Spek gauge, but i would like to get the others working (Oil pressure, fuel qty, volt's). IF so I'll be the first one tossing money your way!!

Pages: [1]
hit counter