Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Jadran

Pages: [1] 2 3 ... 9
It works,THX

Assetto Corsa (32-bit) 1.3.2 plugin won't start in SimDash v7 but 64-bit version work OK

General Discussions / Re: connection meter to the Pro-Gauge
« on: February 13, 2015, 07:03:27 pm »
I only have this and I hope it will help

406 SAGEM Dashboard

General Discussions / Re: counter 406 help
« on: July 04, 2014, 10:45:29 pm »
I think pin 20 is for fuel level gauge but not sure.

For all other you will find sheme here:

or here

General Discussions / Re: counter 406 help
« on: July 02, 2014, 09:03:14 am »
I hope that these images help   ;)

Everything you need you will find here:

Your new scheme is OK but I do not understand next sentence (One other thing but to turn on the orange LED speedometer I have to make a change in I with the pro-gauge light? )  :)

That would be it,on blue connector pin 18 should be water temp and black connector pin 1 is fuel sensor..

Look here: read and scrolll down to see picture (1000 words  ;) )

General Discussions / Re: Alfa Romeo 147 Cluster Pin's
« on: March 09, 2014, 09:32:14 pm »
Here is link with wiring scheme that I found   ;)

General Discussions / Re: Alfa Romeo 147 Cluster Pin's
« on: March 09, 2014, 08:33:38 pm »
This is a CAN-BUS protocol, and so far can not be run that cluster as far as I know  :-\

Show off your build / Re: My WIP dashboard / cockpit
« on: January 10, 2014, 03:23:30 pm »
Do not let confuse the numbers on cluster and numbers on the connector ...
Connect how shown on picture if you have all 3 connectors (If this is a cluster for E36)  ;)

Here is pic for blue connector:

and black

If you disassembling connector will see numbers on connector..


If you do not have the connectors used numbers as printed on the cluster

General Discussions / Re: Can anyone help me - BMW-E46-SMG-M3 Wiring.??
« on: December 08, 2013, 07:08:19 pm »
Unfortunately it is not possible to run this cluster (and most of the after 2000 years) with the Pro-Gauge or Rev Burner because it use the CAN BUS protocol.
I hope that Cristiano in the near future resolve this  ;D

General Discussions / Re: Simdash up date for PCARS
« on: December 02, 2013, 06:25:09 pm »
THX  ;)

General Discussions / Re: new project help needed
« on: November 27, 2013, 09:09:05 am »
thanks paulie!!

i have ordered the pro-gauge yesterday.
can you give me an wirering diagram for an bmw e36 cluster?
i am an noob an have no idea to conect them to the cluster.

You can find everything here

Hope that's help  ;)

Pages: [1] 2 3 ... 9
hit counter