Recent Posts

Pages: 1 [2] 3 4 ... 10
11
General Discussions / Re: JC32
« Last post by Cristiano on March 27, 2023, 10:14:59 am »
Hello.
You can use multiple JC32 boards at the same time.

The JC32 configuration tool will only allow you to configure one board at the time, but that is an operation that you normally do once.

Inside the simulator, the two boards will be detected and shown as two independent game controller.

Please let me know if you have questions.

Cristiano
12
General Discussions / JC32
« Last post by blodo on March 27, 2023, 10:09:04 am »
HI

is it possible to use two jc32 controllers at the same time? and how does the software react?

thanks
Mitchell
13
General Discussions / Re: Cannot reset Pro Guage serial number - Help!
« Last post by Cristiano on March 02, 2023, 09:56:48 am »
That's good news.
Let me now if you have other questions in the future.

Regards
Cristiano
14
General Discussions / Re: Cannot reset Pro Guage serial number - Help!
« Last post by SlickR on March 01, 2023, 11:37:09 pm »
Cristiano,

   Hurray! Your firmware did the trick!
It wrote a new serial number automatically without having to edit the config file.
Pretty cool!
Now I own my gauges again.
Thank You! I am VERY HAPPY!!!
15
General Discussions / Re: Cannot reset Pro Guage serial number - Help!
« Last post by Cristiano on March 01, 2023, 10:45:33 am »
I replied to your email.

C.
16
General Discussions / Re: Cannot reset Pro Guage serial number - Help!
« Last post by SlickR on February 28, 2023, 10:08:50 pm »
Here's the pics:

17
General Discussions / Re: Cannot reset Pro Guage serial number - Help!
« Last post by Cristiano on February 28, 2023, 09:58:33 am »
Hello.
Can you please post a picture of your Pro-Gauge board and I will tell you what to do.
There have been  a couple of different versions over the years.

you can also send me an email to contact@symprojects.com

Regards
Cristiano
18
General Discussions / Cannot reset Pro Guage serial number - Help!
« Last post by SlickR on February 28, 2023, 04:40:11 am »
I used to run v6.0 and when my ProGuage serial would get corrupted I would do like it says, goto SimDash.exe.config and edit the lines "show test controls" from False to True.
Then go into Tach and select the change serial button, etc...It always worked. Never a problem.

My problem now is when I go into SimDash.exe.config there is no "show test controls" lines anywhere?
I can't edit what isn't there.
I am running v45.0.1 on Windows10 64
This is the first time my serial number corrupted since I installed v45.0.1 only 3 weeks ago.
Previously I was running v6.0

* I upgraded the Firmware to v2.
I still see no "show test controls" in SimDash.exe.config.

How do I reset my serial number?
19
General Discussions / Re: Nascar 2003 again!
« Last post by SwiftyOne on October 22, 2022, 07:21:14 pm »
Hi Cristiano,
That's fixed it....Thanks, Cristiano what would we do without you ;D
Steve ;)
20
General Discussions / Re: Nascar 2003 again!
« Last post by Cristiano on October 22, 2022, 12:06:30 pm »
Pages: 1 [2] 3 4 ... 10
hit counter