rotary encoder not working on jc32 joystick controller

[davidgrunill]

hi and need some help please.

i have a new jc32 controller and the rotary encoders are not working correctly..i think.

i have an encoder wired into pins 1&2 and the middle pin wired to ground.

i have used the config tool to set pins 1&2 to encoder.

when i move the encoder it does not signal every click,it is 11 00 11 00 if that makes sense,i have tested in windows joystick applet and confirms this,also in game.

if i open the debug window in the config tool the encoder is 1111111 so its showing as working there in both directions..but not in any game or windows

any ideas?

david

[Cristiano]

Hello.
when you open the Debug windows in the configuration tool and rotate the encoder clockwise, does the window display that button 2 is pressed?

and that button 1 is pressed when you rotate the rotary encoder anti-clockwise?
the windows joystick applet is not very good for checking if a button is pressed or not, because pressed are very fast and often you can't see them.
you should use the debug window in the configuration tool instead.

Regards
Cristiano

[davidgrunill]

hi

yes it all works in debug mode,i tested it..as you said windows applet=not very good

all working good so far.