type r + revburner

[oidipodas]

hello
i have a type r rev counter and the revburner but i have problem calibrating,when i calibrate it in one test rpm setting such as 10% if i test another that i set before the rpm is not the same
 

[Mortos]

If I understand correctly, you're calibrating to a single percentage and expect the tach to synchronise with your RevBurner.

Sadly, this isn't the way it works. You need to calibrate for each individual percentage so the needle corresponds to the chosen RPM setting.

[Cristiano]

I think oidipodas means that if he calibrates the 10% point and then the 20% point, when he goes back to the 10% point it is not in the right position, but a little higher or a little lower.

this is caused by the poor quality of the rev counter

[oidipodas]

yes cristiano this is i mean, thanks for the info maybe i need to buy a better rev counter