Author Topic: Led & Button on same pcb  (Read 6200 times)

Zizza

  • Approved Newbie
  • *
  • Posts: 27
    • View Profile
    • Email
Led & Button on same pcb
« on: March 15, 2013, 01:34:02 pm »
I guys
I'm creating my new GT/Rally wheel but I need a little help. Basically I need to be able to connect in the same pcb, buttons and LED. Any advice?

Cristiano

  • Administrator
  • Hero Member
  • *****
  • Posts: 1360
    • View Profile
    • SymProjects
    • Email
Re: Led & Button on same pcb
« Reply #1 on: March 17, 2013, 09:50:04 pm »
Hello.
Do you know what product you want to use?

The Pro-Shift can drive LEDs, but can only handle 4 buttons.

The DLC-247 can handle LEDs too, but not the buttons. it requires a separate controller for that, like the JC24 or JC32.

Regards
Cristiano

Zizza

  • Approved Newbie
  • *
  • Posts: 27
    • View Profile
    • Email
Re: Led & Button on same pcb
« Reply #2 on: March 18, 2013, 12:54:15 pm »
Hello.
Do you know what product you want to use?

The Pro-Shift can drive LEDs, but can only handle 4 buttons.

The DLC-247 can handle LEDs too, but not the buttons. it requires a separate controller for that, like the JC24 or JC32.

Regards
Cristiano


LOL!  ::)
Thanks Cristiano!! i haven't read the pro-shift descripion at all  :P but the pro-shift is nearly perfect for me ... I need to connect 6 buttons and 10 LEDs....
« Last Edit: March 18, 2013, 01:43:47 pm by Zizza »

Zizza

  • Approved Newbie
  • *
  • Posts: 27
    • View Profile
    • Email
Re: Led & Button on same pcb
« Reply #3 on: March 19, 2013, 01:58:12 pm »
I thought I was as an alternative to connect the Pro Shift and the JC24 in a usb hub and then via a single USB cable to PC...
but I don't know if a single USB has enough power for both controllers

Cristiano

  • Administrator
  • Hero Member
  • *****
  • Posts: 1360
    • View Profile
    • SymProjects
    • Email
Re: Re: Led & Button on same pcb
« Reply #4 on: March 19, 2013, 10:46:15 pm »
Using an usb hub to connect pro shift and JC24 should work fine.
I am working on a new version of the pro shift that will have 8buttons instead of 4.
At the moment I have only received the pcbs. I need to upgrade the firmware and that will take some time.

Zizza

  • Approved Newbie
  • *
  • Posts: 27
    • View Profile
    • Email
Re: Re: Led & Button on same pcb
« Reply #5 on: March 20, 2013, 08:39:10 am »
Using an usb hub to connect pro shift and JC24 should work fine.
I am working on a new version of the pro shift that will have 8buttons instead of 4.
At the moment I have only received the pcbs. I need to upgrade the firmware and that will take some time.

NICE!!

If u need a tester i'm with you!  :P

and now i buy a single JC24 for button and when is ready i buy the new pro-shift  ;D

 

hit counter