1
General Discussions / Re: Firmware upgrading Rev Burner
« on: August 22, 2011, 03:27:36 pm »
Thanks Cristiano, nice and easy. 
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussions / Firmware upgrading Rev Burner
« on: August 22, 2011, 02:39:46 pm »
Hi All,
I have just received my new Rev Burner, I noticed it is different to a friends Burner.
I understand that mine does not have jumpers as it is the Rev4 PCB
My question is, if I need to upgrade the firmware at a later date do I have to find a small piece of wire (as in the upgrading firmware pictures) and put it into the 2 empty holes to complete the loop and this will put it into download mode?
http://www.symprojects.com/upgrading-the-firmware/
Thanks
Shane
I have just received my new Rev Burner, I noticed it is different to a friends Burner.
I understand that mine does not have jumpers as it is the Rev4 PCB
My question is, if I need to upgrade the firmware at a later date do I have to find a small piece of wire (as in the upgrading firmware pictures) and put it into the 2 empty holes to complete the loop and this will put it into download mode?
http://www.symprojects.com/upgrading-the-firmware/
Thanks
Shane
Pages: [1]
