« previous next »
Pages: [1]

Author Topic: Trimming a SPI-D?  (Read 18253 times)

mr.w

  • Jr. Member
  • **
  • Posts: 61
    • View Profile
    • Email
Trimming a SPI-D?
« on: September 30, 2012, 07:29:54 am »
Hi, I am in the process of assembling a Speedometer and had a question of trimming my SPI-D. I would like to cut away some of the lower corners (bottom two mounting holes), I do not see any traces in these corners so I assume this will be ok, but I just wanted to check first.
Logged

Cristiano

  • Administrator
  • Hero Member
  • *****
  • Posts: 1360
    • View Profile
    • SymProjects
    • Email
Re: Trimming a SPI-D?
« Reply #1 on: September 30, 2012, 12:57:28 pm »
it depends how much you cut.

if you stay near the holes it should be ok.

Logged

mr.w

  • Jr. Member
  • **
  • Posts: 61
    • View Profile
    • Email
Re: Trimming a SPI-D?
« Reply #2 on: October 01, 2012, 03:47:57 am »
I will stay pretty close but won't touch the traces.  I will report back
Logged

mr.w

  • Jr. Member
  • **
  • Posts: 61
    • View Profile
    • Email
Re: Trimming a SPI-D?
« Reply #3 on: October 03, 2012, 11:48:34 am »
So here it is 90% complete, just a little clean up left.  I put this together so I would not have to purchase a stand alone Speedo and the T500 is a lot bigger than my old G25 so I had to move my cluster.
Logged
Pages: [1]
« previous next »
 

hit counter