help please

[freelance100]

I got the JC24 Joystick Controller having trouble wiring some pics of some wired up would help thx in advance 

[Cristiano]

Hi.
What are you trying to connect to the controller?
Buttons? Rotary encoders?
How many?

Regards
Cristiano

[freelance100]

hi six push buttons its all new to me and can I ask do u have to solder anything on the controller board cause there are holes on it because the board don't look like the one on the site when u plug to usb the config software says no device attached sorry for being a pain its all new to me thanks for ur time

[freelance100]

someone plz help 

[Zizza]

try another usb port

[Cristiano]

Sorry can you send a picture of your board?

hi six push buttons its all new to me and can I ask do u have to solder anything on the controller board cause there are holes on it because the board don't look like the one on the site when u plug to usb the config software says no device attached sorry for being a pain its all new to me thanks for ur time

[freelance100]

photo of the board 

[Cristiano]

I can't see well in the picture, but on the board there sould be 10 pins, numered from 1 to 10

buttons have to be connected to those pins, like in the picture here:

http://www.symprojects.com/wp-content/uploads/JC24JoystickController_90EE/matrixJC24.jpg

picture is from this page:

http://www.symprojects.com/shop/jc24-joystick-controller/