Pro Gauge Error Issue

[Eduardo Moreira]

Cristiano good night. I never managed to import settings. the "error loading settings" message always appears. I've done your suggestion in the topic about the error and did not work .I must to import the settings of the number of cylinders? . Another question: I can connect the adapter signal to the tachometer signal or it is only for entries s1...s6.

Regards
Eduardo

[H.Guedes]

Cristiano good night. I never managed to import settings. the "error loading settings" message always appears. I've done your suggestion in the topic about the error and did not work .I must to import the settings of the number of cylinders? . Another question: I can connect the adapter signal to the tachometer signal or it is only for entries s1...s6.

Regards
Eduardo

S1...S6 is used only for oil/water temp, fuel, oil pressure and so...  RPM is specified to the tachometer.

Pelo nick és PT. o SPD é apenas para Velocímetro e o RPM é para as rotações. as outras saídas usas para os outros manometros.

Cpts

[Cristiano]

Hello.
if you post your file with the settings I will test it and check what the problem is.

regards
Cristiano

Cristiano good night. I never managed to import settings. the "error loading settings" message always appears. I've done your suggestion in the topic about the error and did not work .I must to import the settings of the number of cylinders? . Another question: I can connect the adapter signal to the tachometer signal or it is only for entries s1...s6.

Regards
Eduardo

[Clubsport]

Same problem here....
I managed to survive my Pro-Gauge-Settings, but unable to bring my DLC-247 back to life....
Tried to change all serials in my xml-config to the 368 (shown in the DLC-247 tab in SimDash) , but still "Error importing settings"....

Can not upload my xml, because forum says the upload-folder is full....