[AR 156] Speedo, REV, Backlight

[Zoszko]

Hello Everyone,

I am new here, but I really need your help now.
So first of all I have managed to get the wiring diagrams from the eLearn software, I can get the rev counter moving, but not the way I want it... the speedo does not move at for me, and the backlight for the speedo is always off. I have checked the bulbs they are ok.
So the rev goes all the way up to 6k and than falls back down, the speedo does not move at all. I have got tools (eg.: oscilloscope), the square wave looks ok from here.

All suggestions are welcome.

[Zoszko]

Update #1: I have hacked the backlight : https://www.flickr.com/photos/zoszko/14700229675/

[H.Guedes]

Hello Everyone,

I am new here, but I really need your help now.
So first of all I have managed to get the wiring diagrams from the eLearn software, I can get the rev counter moving, but not the way I want it... the speedo does not move at for me, and the backlight for the speedo is always off. I have checked the bulbs they are ok.
So the rev goes all the way up to 6k and than falls back down, the speedo does not move at all. I have got tools (eg.: oscilloscope), the square wave looks ok from here.

All suggestions are welcome.

What is the max RPM that you configure is pro-gauge/rev burner? Because if you set for example max speed 210km/h and in game you go more than that the needle comes down. so you need to configure the max limit a littler higher.

So for example if your game the max RPM is 8000 RPM try to configure it in max value to 9000. this way it's impossible the needle comes down because you don't reach a value higher than the limit that you configure

Sorry for bad english

[Zoszko]

Hey,

Thanks for your reply, but you are way off-topic with this.