simdash

[steve o]

Can anybody advise of how to save dial set up with pro gauge i set the dials via tick the little box  to enable it,i get as far as export  save it  ,switch of pc only to find i have to set my dials again  so im a little lost any help would be great !!!!!!

[SlickR]

I had the same problem, it was that the serial# of my ProGauge board was corrupted.
I assigned a new one, and I could then save my gauges export with success.

[steve o]

ok i see how would i go about  getting a new serial number so i can assign it again !! thanks for the reply

[Nimzovich]

Here is the procedure to reset your ProGauge serial number:

Edit SimDash.exe.config which is in the SimDash' installation folder
change these lines:


        <setting name="ShowTestControls" serializeAs="String">
          <value>False</value>
        </setting>


to:


        <setting name="ShowTestControls" serializeAs="String">
          <value>True</value>
        </setting>


Start SimDash.
In the Pro-Gauge configuration screen  (RPM section) there is a button that says "Set Serial Number"
Click it and confirm (board should be connected at this point)
Unplug and plug the board in again
you won't be able to import the old settings, but you have to recreate new one and them export them.