Author Topic: Load cell amplifier  (Read 5921 times)

kikie

  • Approved Newbie
  • *
  • Posts: 41
    • View Profile
Load cell amplifier
« on: December 31, 2012, 05:10:41 am »
I was wondering if symproject is going to develop a , at least 12-bit, load cell amplifier with a, whether or not with a variable gain control (if that is really necessary) to which you can also connect a pressure sensor/transducer or something that meassure the pressure from an hydraulic system and converts this signal into an elektrical signal? Or a, at least 12-bit joystick with a load cell amplifier?
« Last Edit: December 31, 2012, 05:23:52 am by kikie »

Cristiano

  • Administrator
  • Hero Member
  • *****
  • Posts: 1360
    • View Profile
    • SymProjects
    • Email
Re: Load cell amplifier
« Reply #1 on: December 31, 2012, 11:48:58 am »
Hello.
I Will investigate it, because I am not familiar with this type of amplifier.

Thank you

kikie

  • Approved Newbie
  • *
  • Posts: 41
    • View Profile
Re: Load cell amplifier
« Reply #2 on: December 31, 2012, 01:07:02 pm »
Thank you.

What do you think of this: Click here

Problem is, that I'm interested in one but I can't get a hold of Leo Bodnar and Derek speare wasn't really helpful when I asked him questions.

I bought several items from symprojects without any problems, so I want one, if symprojects had one, from symprojects.
« Last Edit: December 31, 2012, 01:10:09 pm by kikie »

kikie

  • Approved Newbie
  • *
  • Posts: 41
    • View Profile
Re: Load cell amplifier
« Reply #3 on: December 31, 2012, 07:27:58 pm »
Can I connect a pressure sensor to one of the analogue inputs of the JC32 Joystick Controller instead of a potmeter? Without using an amplifier.
« Last Edit: January 01, 2013, 10:47:53 am by kikie »

Cristiano

  • Administrator
  • Hero Member
  • *****
  • Posts: 1360
    • View Profile
    • SymProjects
    • Email
Re: Load cell amplifier
« Reply #4 on: January 02, 2013, 03:14:52 pm »
Can I connect a pressure sensor to one of the analogue inputs of the JC32 Joystick Controller instead of a potmeter? Without using an amplifier.

the analog inputs of the JC32 controller expect a voltage range from 0V to 5V.

If the output signal of the pressure is within this range, it can be used with the JC32.

Regards
Cristiano

 

hit counter